Pack 10 Tubes LED T8 18W 1800Lm 6000ºK Glass 120Cm 40.000H [TC-T8-18WC-CW-PK10-AP]
-20%£ 68.21
£ 54.35
Advantages of buying in GreenIce?
- 100% free returns
- 60 day return
- More than 20,000 products in our catalog
- Up to 10 year warranty
Pack 10 Tubes LED T8 18W 1800Lm 6000ºK Glass 120Cm 40.000H [TC-T8-18WC-CW-PK10-AP]
Pack of 10 glass LED tubes with connection at both ends and SMD2835 light source. Its direct connection to the network allows to eliminate the residual consumption of ballasts and primers, allowing greater durability and less maintenance, a instant ignition and the absence of the flicker effect (blinking of the light). No noise.
It has a high efficiency (100 Lm/W) consuming 18W through SMD2835 type LEDs, managing to provide a luminous flux of 1800Lm uniformly distributed by an opal glass diffuser from which it is obtained. a color rendering index of 80.Its consumption represents a value of 18kWh/1000h, reducing the amount of energy billed and the emissions of polluting gases into the atmosphere.
It has a IP25 degree of protection (valid for dust and humidity indoors), in addition to being robust enough for the required mechanical demands.This tube is available in cold white (6000°K). The indicated color temperature may suffer fluctuations corresponding to a tolerance of 7%.
Installation instructions for led tubes:
- Step 1: Disconnect power.
- Step 2: Remove conventional fluorescent tube.
- Step 3: Unscrew and remove primer, then disconnect wires from ballast.< li>Step 4: Connect the phase to one end of the tube and the neutral to the other end of the tube.
- Step 5: Place the new led tube and connect the electrical current.
Where is it convenient to install LED tubes?
Led tubes are normally installed in places with many hours of lighting: car park lighting, Hotel lighting, University and College lighting, office lighting, shopping center lighting.
For long periods of lighting it is recommended to use LED tubes with an aluminum body as it dissipates The heat is much better.